Cisco ONS 15454 SDH Configuration Manual page 502

[no] rpr-ieee ri {primary | secondary} peer peer-MAC-address
[no] rpr-ieee ri {primary | secondary} peer peer-MAC-address
Use this command to set the mode for the IEEE 802.17b based RPR interface and the peer address, or
disables the feature. Use the no form to disable the feature.
Syntax Description Parameter
primary
secondary
peer-MAC-address
Command Default
The default is disabled.
Command Modes
IEEE 802.17b based RPR interface configuration
Usage Guidelines The peer MAC address is in hexadecimal format. If you change the MAC address, you must repeat this
command with the new address.
In this command, interface can be shortened to int. It is not necessary to use the RI term if you are
specifically indicating a primary or secondary peer, as in the following example.
Examples In this example, interface is shortened to int.
Router(config)# int rpr-ieee 0
Router(config-if)# rpr-ieee ri mode primary peer 00.24.A4.0E.9A.68
Related Commands
rpr-ieee ri {primary | secondary} delay interval
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
A-26
Description
Single traffic queue mode.
Dual traffic queue mode.
The MAC of the alternate station. For a primary station, this command
enters the MAC address of the secondary station. For a secondary station,
this command enters the primary station MAC address.
Appendix A Command Reference