Configuring The Gigabit Ethernet Interface For The Ml1000-2 - Cisco ONS 15454 SDH Configuration Manual

Configuring the Gigabit Ethernet Interface for the ML1000-2

Command
Step 3
Router(config-if)# flowcontrol send {on |
off | desired}
Step 4
Router(config-if)# no shutdown
Step 5
Router(config)# end
Step 6
Router# copy running-config startup-config
Configuring the Gigabit Ethernet Interface for the ML1000-2
To configure IP address or bridge-group number, autonegotiation, and flow control on an ML1000-2
Gigabit Ethernet interface, perform the following procedure, beginning in global configuration mode:
The default setting for the negotiation mode is auto for the Gigabit Ethernet and Fast Ethernet interfaces.
Note
The Gigabit Ethernet port always operates at 1000 Mbps in full-duplex mode.
Command
Step 1
Router# interface gigabitethernet number
Step 2
Router(config-if)# {ip address ip-address
subnet-mask | bridge-group
bridge-group-number }
Step 3
Router(config-if)# [no] negotiation auto
Step 4
Router(config-if)# flowcontrol {send |
receive} {on | off | desired}
Step 5
Router(config-if)# no shutdown
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
4-6
Chapter 4 Configuring Interfaces
Purpose
(Optional) Sets the send flow control value for an
interface. Flow control works only with port-level
policing. ML-Series card Fast Ethernet port flow
control is IEEE 802.3x compliant.
Since Fast Ethernet ports support only
Note
symmetric flow control the flowcontrol
send command controls both the receive
and send flow control operations.
Enables the interface by preventing it from
shutting down.
Returns to privileged EXEC mode.
(Optional) Saves your configuration changes to
TCC2/TCC2P flash database.
Purpose
Activates interface configuration mode to
configure the Gigabit Ethernet interface.
Sets the IP address and subnet mask.
or
Assigns a network interface to a bridge group.
Sets negotiation mode to auto. The Gigabit
Ethernet port attempts to negotiate the link with
the partner port.
If you want the port to force the link up no matter
what the partner port setting is, set the Gigabit
Ethernet interface to no negotiation auto.
(Optional) Sets the send or receive flow control
value for an interface. Flow control works only
with port-level policing. ML-Series card Gigabit
Ethernet port flow control is IEEE 802.3z
compliant.
Enables the interface by preventing it from
shutting down.