Table 14-7 Cos-Based Packet Statistics Command; Table 14-8 Commands For Cos-Based Packet Statistics - Cisco ONS 15454 SDH Configuration Manual
Hide thumbs
Also See for ONS 15454 SDH:
- User manual (62 pages) ,
- Manual (40 pages) ,
- Reference manual (22 pages)
Table of Contents
Advertisement
Configuring CoS-Based Packet Statistics
For IEEE 802.1Q (QinQ) enabled interfaces, CoS accounting is based only on the CoS value of the outer
Note
metro tag imposed by the service provider. The CoS value inside the packet sent by the customer network
is not considered for CoS accounting.
For information on the enhanced microcode image, see the
page
To enable CoS-based packet statistics on an interface, use the interface configuration level command
defined in
Table 14-7
CoS-Based Packet Statistics Command
Command
Router(config-if)# cos accounting
After configuring CoS-based packet statistics on the ML-Series card, the statistics can be viewed
through a variety of show commands. To display this information, use one of the commands in
Table 14-8
Table 14-8
Command
Router# show interface type number cos
Router# show interface type
number.subinterface-number cos
Example 14-19
Example 14-19 Commands for CoS-Based Packet Statistics Examples
Router# show interface gigabitethernet 0.5 cos
GigabitEthernet0.5
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
14-30
3-11.
Table
14-7.
in EXEC mode.
Commands for CoS-Based Packet Statistics
shows examples of these commands.
Stats by Internal-Cos
Input: Packets
Bytes
Cos 0: 31
2000
Cos 1:
Cos 2: 5
400
Cos 3:
Cos 4:
Cos 5:
Cos 6:
Cos 7:
Output: Packets
Bytes
Cos 0: 1234567890
Cos 1: 31
2000
Cos 2:
Purpose
Enables CoS-based packet statistics to be recorded at the specific
interface and for all the subinterfaces of that interface. This
command is supported only in interface configuration mode and not
in subinterface configuration mode.
The no form of the command disables the statistics.
Purpose
Displays the CoS-based packet statistics available for
an interface.
Displays the CoS-based packet statistics available for
a FastEthernet or Gigabit Ethernet subinterface. POS
subinterfaces are not eligible.
1234567890
Chapter 14 Configuring Quality of Service
"Multiple Microcode Images" section on
Advertisement
Table of Contents
