Understanding Vlan-Transparent And Vlan-Specific Services; Table 9-1 Vlan-Transparent Service Versus Vlan-Specific Services - Cisco ONS 15454 SDH Configuration Manual

Understanding VLAN-Transparent and VLAN-Specific Services

!
interface POS0.2
encapsulation dot1Q 40
bridge-group 40
Example 9-2
bridge 30 protocol ieee
bridge 40 protocol ieee
!
!
interface FastEthernet0
no ip routing
no ip address
mode dot1q-tunnel
bridge-group 30
!
interface FastEthernet1
no ip address
mode dot1q-tunnel
bridge-group 40
!
interface POS0
no ip address
crc 32
pos flag c2 1
!
interface POS0.1
encapsulation dot1Q 30
bridge-group 30
!
interface POS0.2
encapsulation dot1Q 40
bridge-group 40
Understanding VLAN-Transparent and VLAN-Specific Services
The ML-Series card supports combining VLAN-transparent services and one or more VLAN-specific
services on the same port. All of these VLAN-transparent and VLAN-specific services can be
point-to-point or multipoint-to-multipoint.
This allows a service provider to combine a VLAN-transparent service, such as IEEE 802.1Q tunneling
(QinQ), with VLAN-specific services, such as bridging specific VLANs, on the same customer port. For
example, one customer VLAN can connect to Internet access and the other customer VLANs can be
tunneled over a single provider VLAN to another customer site, all over a single port at each site.
Table 9-1
Table 9-1
VLAN-Transparent Services
Bridging only
One service per port
Applies indiscriminately to all VLANs on the
physical interface
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
9-6
Router B Configuration
outlines the differences between VLAN-transparent and VLAN-specific services.
VLAN-Transparent Service Versus VLAN-Specific Services
Chapter 9 Configuring IEEE 802.1Q Tunneling and Layer 2 Protocol Tunneling
VLAN-Specific Services
Bridging or routing
Up to 254 VLAN-specific services per port
Applies only to specified VLANs