Chapter 11 Configuring Networking Protocols
Monitoring and Verifying IP Multicast Operation
After IP multicast routing is configured, you can monitor and verify its operation by performing the
commands listed in
Table 11-10
Command
Router# show ip mroute
Router# show ip pim neighbor
Router# show ip pim interface
Router# show ip pim rp
Table
11-10, from privileged EXEC mode.
IP Multicast Routing Show Commands
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
Monitoring and Verifying IP Multicast Operation
Purpose
Shows the complete multicast routing table and the combined
statistics of packets processed.
When used in EXEC mode, lists the PIM neighbors
discovered by the Cisco IOS software.
Displays information about interfaces configured for PIM.
When used in EXEC mode, displays the active rendezvous
points (RPs) that are cached with associated multicast routing
entries.
11-35