Accelerated Aging To Retain Connectivity; Rstp; Supported Rstp Instances; Port Roles And The Active Topology - Cisco ONS 15454 SDH Configuration Manual

Chapter 7 Configuring STP and RSTP

Accelerated Aging to Retain Connectivity

The default for aging dynamic addresses is 5 minutes, which is the default setting of the bridge
bridge-group-number aging-time global configuration command. However, a spanning-tree
reconfiguration can cause many station locations to change. Because these stations could be unreachable
for 5 minutes or more during a reconfiguration, the address-aging time is accelerated so that station
addresses can be dropped from the address table and then relearned.
Because each VLAN is a separate spanning-tree instance, the switch accelerates aging on a per-VLAN
basis. A spanning-tree reconfiguration on one VLAN can cause the dynamic addresses learned on that
VLAN to be subject to accelerated aging. Dynamic addresses on other VLANs can be unaffected and
remain subject to the aging interval entered for the switch.

RSTP

RSTP provides rapid convergence of the spanning tree. It improves the fault tolerance of the network
because a failure in one instance (forwarding path) does not affect other instances (forwarding paths).
The most common initial deployment of RSTP is in the backbone and distribution layers of a Layer 2
switched network; this deployment provides the highly available network required in a service-provider
environment.
RSTP improves the operation of the spanning tree while maintaining backward compatibility with
equipment that is based on the (original) IEEE 802.1D spanning tree.
RSTP takes advantage of point-to-point wiring and provides rapid convergence of the spanning tree.
Reconfiguration of the spanning tree can occur in less than 2 second (in contrast to 50 seconds with the
default settings in the IEEE 802.1D spanning tree), which is critical for networks carrying
delay-sensitive traffic such as voice and video.
These sections describe how RSTP works:
•
•
•
•
•
•

Supported RSTP Instances

The ML Series supports per-VLAN rapid spanning tree (PVRST) and a maximum of 255 rapid
spanning-tree instances.

Port Roles and the Active Topology

The RSTP provides rapid convergence of the spanning tree by assigning port roles and by determining
the active topology. The RSTP builds upon the IEEE 802.1D STP to select the switch with the highest
switch priority (lowest numerical priority value) as the root switch as described in the
Root Switch" section on page
Supported RSTP Instances, page 7-9
Port Roles and the Active Topology, page 7-9
Rapid Convergence, page 7-11
Synchronization of Port Roles, page 7-12
Bridge Protocol Data Unit Format and Processing, page 7-13
Topology Changes, page 7-14
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
7-3. Then the RSTP assigns one of these port roles to individual ports:
Accelerated Aging to Retain Connectivity
"Election of the
7-9