Cisco ONS 15454 SDH Configuration Manual page 496

rpr-ieee protection timer fast rate {east | west}
rpr-ieee protection timer fast rate {east | west}
Use this command to configure the fast protection timer value for the specified IEEE 802.17b based RPR
span.
Syntax Description Parameter
east
west
rate
Defaults
N/A
Command Modes
IEEE 802.17b based RPR interface configuration
Usage Guidelines This rate determines how quickly the fast protection timer sends a protection message after a protection
event occurs.
In this command, protection can be shortened to prot.
Examples In this example, interface is shortened to int.
Router(config)# int rpr-ieee 0
Router(config-if)# rpr-ieee prot timer fast 5 east
Related Commands
rpr-ieee protection timer slow
Cisco ONS 15454 and Cisco ONS 15454 SDH Ethernet Card Software Feature and Configuration Guide, R8.0
A-20
Description
Pertains to configuration for eastbound span traffic.
Pertains to configuration for westbound span traffic.
The rate, expressed in milliseconds, at which the fast protection timer sends
a protection message. This occurs after a protection event on a particular
(east or west) span. Range is 1 to 20 milliseconds.
Appendix A Command Reference