Ptz Configuration; Configuring Basic Ptz Parameters - 3xLogic VX-3M-F-AWD User Manual

5.4 PTZ Configuration

On the event configuration page, click

hide it.
NOTE:
Click the direction buttons to control the pan/tilt movements.

Click the zoom/iris/focus buttons to realize lens control.

The functions vary depending on different camera models.


CONFIGURING BASIC PTZ PARAMETERS

The user can configure basic PTZ parameters, including proportional pan, preset freezing, preset speed, etc.
1. Enter the Basic Settings interface: Configuration > PTZ > Basic Settings.
2. Configure the following settings:
Basic Parameters: Set the basic PTZ parameters.

► Proportional Pan: If you enable this function, the pan/tilt speeds change according to the amount of
zoom. When the camera is zoomed in, the pan/tilt speed will be slower to keep the image from
moving too fast on the live view image.
► Preset Freezing: This function enables the live view to switch directly from one scene defined by a
preset to another, without showing the middle areas between these two, to ensure surveillance
efficiency. It can also reduce the use of bandwidth in a digital network system.
NOTE:
Preset freezing function is invalid when calling a pattern.
► Preset Speed: The user can set the speed of a defined preset from 1 to 8.
Manual Control Speed: The manual control speed can be set as Compatible, Pedestrian, Non-motor
►
Vehicle, Motor Vehicle or Auto.
► Compatible: Using this option ensures the control speed is set the same as the Keyboard Control
Speed.
Pedestrian: Choose Pedestrian when the camera is intended to monitor pedestrians/people.
►
► Non-motor Vehicle: Choose Non-motor Vehicle when monitoring objects larger than people but
10385 Westmoor Drive, Suite 210, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
VISIX S-Series Network Camera | USER MANUAL v6.0
to show the PTZ control panel or click to
Basic Settings
Figure 5-26
52