Configuring Capture Schedule - 3xLogic VX-3M-F-AWD User Manual

Post-record: The time you set to stop recording after the scheduled time or event. For example, if an

alarm triggered recording ends at 11:00, and the post-record time is set as 5 seconds, the camera
records until 11:00:05.
The Post-record time can be configured as 5 s, 10 s, 30 s, 1 min, 2 min, 5 min or 10 min.
Stream Type: The user can select the stream type for recording; Main Stream, Sub-Stream and Third

Stream are selectable. If you select the sub-stream, you can record for longer with the same storage
capacity.
NOTE:
The Pre-record and Post-record parameters vary depending on different camera models.
4. Click OK to save advanced settings.
5. Select a Record Type. The record type can be Continuous, Motion, Alarm, Motion | Alarm, Motion &
Alarm, and Event.
Normal: If you select Continuous, the video will be recorded automatically according to the time of

the schedule.
Record Triggered by Motion Detection: If you select Motion, the video will be recorded when the

motion is detected. Besides configuring the recording schedule, you have to set the motion detection
area and toggle the Trigger Channel checkbox in the Linkage Method of Motion Detection settings
interface. For detailed information, refer to Motion Detection.
Record Triggered by Alarm: If you select Alarm, the video will be recorded when the alarm is

triggered via the external alarm input channels. Besides configuring the recording schedule, you have
to set the Alarm Type and toggle Trigger Channel checkbox in the Linkage Method of Alarm Input
settings interface. For detailed information, refer to Alarm Input.
Record Triggered by Motion & Alarm: If you select Motion & Alarm, the video will be recorded when

the motion and alarm are triggered at the same time. Besides configuring the recording schedule, you
have to configure the settings on the Motion Detection and Alarm Input settings interfaces.
Record Triggered by Motion | Alarm: If you select Motion | Alarm, the video will be recorded when

the external alarm is triggered or if motion is detected. Besides configuring the recording schedule,
you have to configure the settings on the Motion Detection and Alarm Input settings interfaces.
Record Triggered by Event: If you select to record by event, the video will be recorded when any of

the events are triggered.
6. Click

CONFIGURING CAPTURE SCHEDULE

Purpose:
The user can configure scheduled snapshots and event-triggered snapshots. Captured stillshots can be stored
in local storage or network storage.
Steps:
1. Enter the Snapshot settings interface: Configuration > Storage > Storage Settings > Capture
10385 Westmoor Drive, Suite 210, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
VISIX S-Series Network Camera | USER MANUAL v6.0
to save the settings.
31