Camera Configuration; Configuring Network Settings; Basic Settings - 3xLogic VX-3M-F-AWD User Manual

6

Camera Configuration

6.1 Configuring Network Settings

NOTE: Functions and settings configurations vary depending on different camera models.

BASIC SETTINGS

Configuring TCP/IP Settings
Purpose:
TCP/IP settings must be properly configured before you operate the camera over network. IPv4 and IPv6 are
both supported.
Steps:
1. Enter the TCP/IP settings interface: Configuration > Network > Basic Settings > TCP/IP
2. Configure the NIC settings, including the IPv4(IPv6) Address, IPv4(IPv6) Subnet Mask and IPv4(IPv6)
Default Gateway.
3. Click
Click Test to make sure that the IP address is valid.
NOTE: If the DHCP server is available, you can check
network settings from that server.
The valid value range of Maximum Transmission Unit (MTU) is 1280 to 1500.

Multicast sends a stream to the multicast group address and allows multiple clients to acquire the stream

at the same time by requesting a copy from the multicast group address.
Before utilizing this function, you have to enable the Multicast function of your router and configure the

gateway of the network camera.
10385 Westmoor Drive, Suite 210, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
TCP/IP Settings
Figure 6-1
to save the above settings
.
VISIX S-Series Network Camera | USER MANUAL v6.0
to automatically obtain an IP address and other
60