3xLogic VX-3M-F-AWD User Manual page 85

Select the Time Zone
Purpose: When the camera is taken to another time zone, you can use the Time Zone
c.
function to adjust the time. The time will be adjusted according to the original time and the
time difference between the two time zones.
d. From the Time Zone dropdown menu as shown in Figure 6-45, select the Time Zone in
which the the camera resides.
Configuring DST (Daylight Saving Time)
e. Purpose: Daylight Savings Time (DST) is a way of making better use of the natural daylight
by setting your clock forward one hour during the summer months, and back again in the
fall.
f. If your country observes Daylight Savings Time, turn this function on. The time will be
adjusted automatically on DST.
Steps:
1. Enter the DST interface: Configuration > Advanced Configuration > System > DST
2. Toggle the Enable DST checkbox to enable the DST function.
3. Set the date of the DST period.
4. Click
Configuring RS-232
The RS-232 port can be used in two ways:
Parameters Configuration: Connect a computer to the camera through the serial port. Device parameters

can be configured by using software such as HyperTerminal. The serial port parameters must be the same
as the serial port parameters of the camera.
Transparent channel: Connect a serial device directly to the camera. The serial device will be controlled

remotely by the computer through the network.
NOTE:
RS-232 function varies depending on different speed dome models.
Steps:
10385 Westmoor Drive, Suite 210, Westminster, CO 80021 | www.3xlogic.com | (877) 3XLOGIC
Time Sync Manually
Figure 6-44
Time Zone Settings
Figure 6-45
DST Settings
Figure 6-46
to save the settings.
VISIX S-Series Network Camera | USER MANUAL v6.0
85