Installing A Power Synchronized Unit - Fujitsu ETERNUS DX60 S4 Configuration Manual

Chapter 2 Installation
2.3 Installing in a Rack
2.3.1

Installing a Power Synchronized Unit

This section describes how to install a power synchronized unit in a rack.
■ Checking the package contents of the rack mount kit
Check the following package contents to confirm that there are no missing parts. If there are missing parts,
contact your sales representative.
❏ L-shaped bracket: 2
Same for right and left.
❏ M6 cross recessed head screw
with captive washer: 4
■ Procedure for installing a power synchronized unit
Procedure
1
Open the front and rear doors of the rack.
2
Attach the M6 cage nuts to the rear rack pillar.
• Attachment positions
Insert four M6 cage nuts in the 1st and 3rd holes above the power synchronized unit base line.
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide (Power Synchronized Unit)
❏ M3 flat head screw: 4
For attaching L-shaped
brackets
❏ Blank panel: 1
(Rear rack pillars)
3rd position
1st position
Base line of
power synchronized unit
36
Copyright 2017 FUJITSU LIMITED
❏ M6 cage nut: 4
1U (power synchronized unit size)
Used when the holes in the rack
pillars are square
P3AM-8012-10ENZ0