Fujitsu ETERNUS DX60 S4 Configuration Manual page 41

Chapter 2 Installation
2.3 Installing in a Rack
4
Attach the shelf plate to the AC sensor unit.
Use two M4 cross recessed head screws with captive washer to attach the shelf plate to the AC sensor
unit.
M4 cross recessed head screws with captive washer
Up to two AC sensor units can be attached to the same shelf plate. Attach the first AC sensor unit on
the right side when facing the shelf plate as shown in the figure above.
5
Attach the shelf plate to the rack.
Use four M6 cross recessed head screws with captive washer to fasten the shelf plate in the rack.
M6 cross recessed head screws
with captive washer
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide (Power Synchronized Unit)
Shelf plate
(Rear rack pillars)
M6 cross recessed head screws
with captive washer
41
Copyright 2017 FUJITSU LIMITED P3AM-8012-10ENZ0