Fujitsu ETERNUS DX60 S4 Configuration Manual page 37

Chapter 2 Installation
2.3 Installing in a Rack
• Attachment procedure
Clip the M6 cage nut tabs into the desired hole from the inside.
3
Attach the L-shaped brackets to the power synchronized unit.
Use four M3 flat head screws to attach the L-shaped brackets to the power synchronized unit on both
sides.
M3 flat head screws
L-shaped bracket
4
Install the power synchronized unit in the rack.
Use four M6 cross recessed head screws with captive washer to fasten the power synchronized unit in
the rack.
M6 cross recessed head
screws with captive washer
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide (Power Synchronized Unit)
Top view
M6 cage nut
Rack pillar (square)
(Rear rack pillars)
M6 cross recessed head screws
with captive washer
Copyright 2017 FUJITSU LIMITED
M3 flat head screws
L-shaped bracket
37
P3AM-8012-10ENZ0