Fujitsu ETERNUS DX60 S4 Configuration Manual page 66

Chapter 5 Adding a Connecting Device
5.1 Connection Procedure When Adding a Server
2
When two or more servers are added, use the AC sensor units to connect the server UPS
units for the added servers to the power synchronized unit.
An example of connecting AC sensor units, server UPS units, and a power synchronized unit is shown
below.
1
Connect the server UPS units and the AC sensor units.
2
Connect the AC sensor units and the power synchronized unit.
3
When two or more AC sensor units are used, connect the AC sensor units.
For details about the connection procedure when using an AC sensor unit, refer to
AC Sensor Unit" (page
UPS unit for
Server#1
UPS unit for
Server#0
Power synchronized unit
UPS unit for
Server#2
UPS unit for
Server#3
After the procedure is complete, check that power synchronization performs normally if necessary.
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide (Power Synchronized Unit)
58).
Server#1
Server#0
AC SENSOR port
AC sensor unit
Added server
Server#2
Added server
Server#3
Copyright 2017 FUJITSU LIMITED
AC sensor port connection cable
(provided with an AC sensor unit)
Branch connector
AC In port
Power cord (for AC sensor)
(Must be obtained by customers)
66
"4.4.2 Connecting the
End of procedure
P3AM-8012-10ENZ0