Chapter 4 Connection And Settings - Fujitsu ETERNUS DX60 S4 Configuration Manual

Chapter 4
Connection and Settings
This chapter describes the installation and setting procedures for a power synchronized unit and an AC sensor
unit.
If your sales representative or maintenance engineer does not perform the settings of the power synchronized
unit and the AC sensor unit, perform the settings yourself.
Attach labels to each cable that is to be connected and make a note of the connection source and
destination. This helps with cable management and prevents incorrect connections.
For the connection and setting details of a device that is connected to the power synchronized unit, refer to
the manual that is provided with the connected device.
■
Workflow
Perform the following procedure for connection and settings:
Procedure
1
Set the ETERNUS DX/AF.
For details, refer to
2
Turn on the power synchronized unit.
For details, refer to
3
When five or more ETERNUS DX/AF storage systems are installed, connect the cascade
cables.
For details, refer to
4
Connect the power synchronized unit to the server UPS unit.
For details, refer to
5
When three or more server UPS units are connected, connect the AC sensor unit.
For details, refer to
6
Connect the power synchronized unit to the ETERNUS DX/AF.
For details, refer to
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide (Power Synchronized Unit)
"4.1 Setting the ETERNUS DX/AF" (page
"4.2 Turning on the Power Synchronized Unit" (page
"4.3 Connecting Cascade Cables" (page
"4.4.1 Connecting the Server UPS Unit to the Power Synchronized Unit" (page
"4.4.2 Connecting the AC Sensor Unit" (page
"4.5 Connecting to the ETERNUS DX/AF" (page
44
Copyright 2017 FUJITSU LIMITED
45).
50).
53).
58).
61).
End of procedure
57).
P3AM-8012-10ENZ0