Fujitsu ETERNUS DX60 S4 Configuration Manual page 59

Chapter 4 Connection and Settings
4.4 Connecting to the Server UPS Unit
2
Connect the AC sensor unit to the power synchronized unit with the AC sensor port
connection cable.
When connecting the AC sensor port connection cable, check the connector orientation and then
firmly push it all the way in.
When disconnecting the AC sensor port connection cable, hold the tab of the connector while pulling
it out.
2-1
Attach the branch connector to the AC sensor output port of the AC sensor unit.
A branch connector is provided with the AC sensor unit.
Branch connector
2-2
Connect the AC sensor port connection cable to one of the ports on the branch connector that was
attached in
AC sensor port connection cable
2-3
Connect the connector at the other end of the AC sensor port connection cable to the AC SENSOR
port on the power synchronized unit.
Power synchronized unit
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide (Power Synchronized Unit)
AC sensor output port
Step 2-1.
Branch connector
AC SENSOR port
AC sensor port connection cable
59
Copyright 2017 FUJITSU LIMITED P3AM-8012-10ENZ0