Show Port - Avaya P330-ML-ML Reference Manual

Chapter 2 Avaya P330-ML Layer 2 CLI Commands

show port

User level: user, privileged, supervisor
Use the show port command to display port status.
The syntax for this command is:
show port [<mod_num>[/port_num]]
mod_num
(Optional)
port_num
(Optional)
Example: to display the status for port 4 on switch 3
P330-N>show port 3/4
Port Name
------ --------------- --------- ---- ------ ------- ---- ---- -----------------
3/4 Gregory
Show Port Output Fields
Field
Port
Name
Status
Vlan
Level
Neg
Dup
Speed
Type
158
Number of the switch. If you do not specify a number, the ports
on all the switches are shown.
Number of the port on the module (can be a vitrual LAG port
number). If you do not specify a number, all the ports on the
switch are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on switch 4.
Status Vlan Level
no link 1 0
Description
Switch and port number
Name of port
Status of the port (connected, no link, disabled)
VLAN ID of the port
Priority level of the port (0-7)
The autonegotiation status of the port (enabled, disabled)
Duplex setting for the port (full, half)
Speed setting for the port (10Mbps, 100Mbps, 1000Mbps)
Port type, for example:
• 10/100Base-Tx, 1000Base-SX Port, Link Aggregation
Group of 10/100Base-T ports
Neg Dup. Spd. Type
enable half 10M 10/100BaseTx Port
Avaya P330-ML Reference Guide