ip ospf cost
User level: privileged, supervisor.
Use the ip ospf command to configure interface metric.
Use the no ip ospf cost command to set the cost to its default. The default is 1.
The syntax for this command is:
[no] ip ospf cost <cost>
cost
Example:
Router-N(configure-if:marketing) # ip ospf cost 10
Done!
ip ospf dead-interval
User level: privileged, supervisor.
Use the ip ospf dead-interval command to configure the interval before
declaring the neighbor as dead.
Use no ospf dead-interval to set the dead-interval to its default value of 40.
The syntax for this command is:
[no] ip ospf dead-interval <seconds>
seconds
Example:
Router-N(configure-if:marketing) # ip ospf dead-interval 15
ip ospf hello-interval
User level: privileged, supervisor.
Use this command to specify the time interval between OSPF hello messages the
router sends.
Use no ip ospf hello-interval to set the hello-interval to its default.
The default is 10.
Avaya P330-ML Reference Guide
Chapter 3
Avaya P330-ML Layer 3 CLI Commands
integer
Time in seconds (integer value)
279