Table of Contents
Advertisement
Chapter 2
Avaya P330-ML Layer 2 CLI Commands
copy startup-config scp
User level: supervisor
Use the copy startup-config scp command to upload the switch-level
startup configuration from the active bank into a file via SCP.
The syntax for this command is:
copy startup-config scp <filename> <ip> <mod_num>
filename
ip
mod-num
Example:
P330-N# copy startup-config scp c:\config\switch1.cfg 192.168.49.10 5
Username: 330user
Password:
Beginning upload operation ...
This operation may take a few minutes...
Please refrain from any other operation during this time.
For more information , use 'show upload status' command
********************************************************************
* If you are currently running the P330-ML Device Manager
application,*
* it is recommended to exit from it before performing configuration*
* download operations.
********************************************************************
copy startup-config tftp
User level: supervisor
This command applies to the P334T-ML only when it is in "Layer2"
device mode.
Use the copy startup-config tftp command to download a policy
configuration from a TFTP server.
Only parameters that differ from the factory default settings for the switch are
included in the configuration file. Therefore, it is important to reinitialize the
NVRAM to the factory default settings before downloading configuration files
to the switch. To reinitialize the NVRAM, run the nvram initialize
command.
26
The file name (full path)
The IP address of the SCP server
The switch number
Avaya P330-ML Reference Guide
*
Advertisement
Table of Contents
