Table of Contents
Advertisement
set vlan
User level: privileged, supervisor.
If you are at the "privileged" level, you can only access this command in
Configure mode.
Type configure at the command prompt to enter Configure mode if
necessary.
Use the set vlan command to create a router Layer 2 interface.
The syntax for this command is:
set vlan <vlan-id> name <vlan-name>
vlan-id
vlan-name
Example:
Router-N(configure)# set vlan 2 name vlan2
If you wish to enter a name which includes spaces, you must enclose the entire
name in quotation marks, for example "new york".
show copy status
User level: user, privileged, supervisor
Use the show copy status command to show the status of the local
configuration copy operation.
The syntax for this command is:
show copy status
Example:
Router-N> show copy status
Module #1
===========
Module
Source file
Destination file : .router-running
Host
Running state
Failure display
Last warning
Avaya P330-ML Reference Guide
Chapter 3
VLAN number
VLAN name
: 1
: .router-startup
: -
: Idle
: (null)
: No-warning
Avaya P330-ML Layer 3 CLI Commands
247
Advertisement
Table of Contents
