Set Port Static-Vlan - Avaya P330-ML-ML Reference Manual

This command is can not be executed for P332G-ML and P332GT-ML ports and
P334T-ML ports 51, 52 (Gigabit SFP ports). An error message is generated if
you attempt to perform the set port speed command for these ports that
can only work at 1000Mbps speed.
Copper ports in the P332GT-ML can work at 1000Mbps (Full Duplex) only if
autonegotiation is enabled on both cable ends and you are using a 4 pair (8-
wire) Ethernet cable. If autonegotiation is disabled, these ports can work only at
100 Mbps (Full Duplex), and autonegotiation must be disabled on both cable
ends.
The syntax for this command is:
set port speed <mod_num>/<port_num> <10MB|100MB|1GB>
mod_num
port_num
Example:
To configure port 1 on module 4 to 100 Mbps
P330-N# set port speed 4/1 100MB
Port 4/1 speed set to 100 Mbps.

set port static-vlan

User level: privileged, supervisor.
Use the set port static-vlan command to assign static VLANs to ports.
The syntax for this command is:
set port static-vlan [module/port range] [vlan num]
module/port
range
vlan num
Avaya P330-ML Reference Guide
Chapter 2
Number of the switch.
Number of the port on the switch.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
Port range
vlan to bind to port
Avaya P330-ML Layer 2 CLI Commands
103