Show Port - Avaya P333T User Manual

Chapter 6 CLI – Layer 2

show port

Use the show port command to display port status.
The syntax for this command is:
show port [<mod_num>[/<port_num>]]
mod_num
port_num
Output Example:
To display the status for port 4 on switch 3:
P330-N> show port 3/4
Port Name
------ ------- --------- ---- ------ ------- ---- ---- -------------
3/4 John
Show Port Output Fields
Field
Port
Name
Status
VLAN
Level
Neg
Duplex
Speed
50
(Optional) Number of the switch. If you do not specify a
number, the ports on all switches are shown.
(Optional) Number of the port on the switch. If you do not
specify a number, all the ports on the switch are shown.
You can also specify a range of ports separated by a dash, e.g.,
5-13 for ports 5 to 13.
Status Vlan Level
connected 1 4
Description
Switch and port number
The name you assigned to the port
Status of the port (connected, no link, disabled, no Rmt Lnk)
VLAN ID of the port
Priority level of the port (0-7)
The autonegotiation status of the port (enable, disable)
Duplex setting for the port (fdx, hdx)
Speed setting for the port (10, 100)
Neg Dup. Spd. Type
enable half 10M
Avaya P333T User's Guide
100/1000Base-Tx