Table of Contents
Advertisement
snmp-server enable
User level: supervisor
Use the snmp-server command to enable SNMP Access to the switch.
The syntax for this command is:
snmp-server enable [volatile]
volatile
(Optional)
Example:
P330-N>snmp-server enable
Done!
snmp-server enable notifications
User level: supervisor
Use the snmp-server enable notifications command to enable sending all
Simple Network Management Protocol (SNMP) notifications (traps and informs).
The syntax for this command is:
snmp-server enable notifications
Example:
P330-N>snmp-server enable notifications
Done!
snmp-server engineID
User level: supervisor
Use the snmp-server engineID command to change the SNMP Engine ID. Only
the default user can run this command.
Avaya P330-ML Reference Guide
Chapter 2
By default the activation of the snmp-server command is
permanent and automatically stored in the non-volatile
memory. The SNMP server is automatically launched after all
restarts. If the volatile parameter is provided, then the SNMP
service runs only until the stack is reset.
Avaya P330-ML Layer 2 CLI Commands
201
Advertisement
Table of Contents
