Show Port - Avaya C460 Reference Manual

show port

User level: read-only, read-write, admin.
Use the show port command to display port status on I/O modules.
The syntax for this command is:
show port [<module>[/port]]
module
(Optional)
port
(Optional)
Example to display the status for port 4 on switch 3:
C460-1> show port 3/4
Port Name
------ --------------- --------- ---- ------ ------- ---- ---- -----------------
3/4 NO NAME
Show Port Output Fields
Field
Port
Name
Status
Vlan
Level
Neg
Dup
Speed
Type
Avaya C460 Reference Guide
Number of the module (3-6). If you do not specify a number,
the ports on all the modules are shown.
Number of the port on the module. If you do not specify a
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
Status Vlan Level
no link 1 0
Description
Switch and port number
Name of port
Status of the port (connected, faulty, disabled)
VLAN ID of the port
Priority level of the port (0-7)
The autonegotiation status of the port (enabled, disabled)
Duplex setting for the port (full, half)
Speed setting for the port (10, 100, 1000)
Port type, for example:
10/100BASE-TX, GBIC_SX, GBIC_LX, GBIC_not present,
GBIC_unknown
Chapter 2 Avaya C460 CLI Commands
Neg Dup. Spd. Type
enable half 10M 10/100BaseTx Port
187