Set Port Static-Vlan - Avaya P460 Reference Manual

Chapter 2 Avaya P460 CLI Commands
ports.
In auto-negotiation mode, the port's speed is determined by auto negotiation. An
error message is generated if you attempt to set the speed when auto negotiation is
enabled
The syntax for this command is:
set port speed <module>/<port> <10MB|100MB|1GB>
module
port
Example:
To configure port 1 on module 4 to 100 Mbps
P460-1# set port speed 4/1 100MB
Port 4/1 speed set to 100 Mbps.

set port static-vlan

User level: read-write, admin.
Use the set port static-vlan command to assign static VLANs to ports.
The syntax for this command is:
set port static-vlan [module/port range] [vlan num]
module/port
range
vlan range
98
Number of the module (3-6). If you do not specify a number,
the ports on all the modules are shown.
Number of the port on the module. If you do not specify a
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
Port range
vlan to bind to port
Avaya P460 Reference Guide