Extron electronics DSC 301 HD User Manual page 19

Input submenu
This submenu allows the user to configure the active input (see figure 7).
1
2
3
4
5
6
7
8
Figure 7. OSD Menu — Input Submenu
— Select this (see figure 7,
Auto-Image
input.
Input x: Input Format
NOTE: Only input 2 can be changed (RGB or YUV). Input 1 is always composite video
and input 3 is always HDMI.
Input x: Film Mode — Select this (
— Select this (
(Pixel) Start
is 0 to +255, default is 128).
— Select this (
Active (pixels)
(range is dependant on input).
Total Pixels and Phase
phase value for RGB and YUV input signals.
Input x: HDCP Authorized
(default) or off.
NOTE: Applicable to HDMI input 3 only.
When disabled (off) the DSC 301 HD will not display content that requires HDCP, and
displays ether a blank screen or a warning message from the input source.
— Select this (
Input x: EDID
RGB, DVI or HDMI inputs. Set to either match output rate, or a custom user-defined
EDID, or a factory setting (see table
)to start a one-time Auto-Image on the active
1
— Select this ( )to change the active input format.
2
) to turn Film Mode on (auto detect mode) or off.
3
) to adjust the horizontal and vertical pixel start (range
4
) to adjust the horizontal and vertical active pixels
5
— Select this ( ) to set the number of active pixels and the
6
— Select this ( ) to turn the HDCP Authorized on
7
) to change the EDID (resolution and refresh rate) for
8
on page 20 for EDID data).
DSC 301 HD • Operation 13