Rear Panel Connections; Rear Panel Cabling; Inputs And Outputs - Extron electronics DSC 301 HD User Manual

Rear Panel Connections

This section describes how to connect cables to a DSC 301 HD scaler.

Rear Panel Cabling

The illustration below shows the rear panel features of the DSC 301 HD.
DSC 301 HD
POWER
POWER
1 2
1 2
12V
12V
1.0A MAX
1.0A MAX
VIDEO RGB/R-Y,Y,B-Y
VIDEO RGB/R-Y,Y,B-Y
G A

Inputs and Outputs

Input 1 (BNC connector)
A
Input 2 (15-pin HD connector)
B
Input 3 (HDMI connector)
C
Audio inputs 1-3
D
HDMI output
E
A
B
INPUTS
INPUTS
3
3
1
1
HDMI
HDMI
B
C
Figure 1. DSC 301 HD Rear Panel Features
Input 1 — Connect a composite video input to this BNC connector.
Input 2 — Connect a input to this configurable analog 15-pin HD (VGA) connector for
RGBHV, HD component video, or YUVi signals.
The analog input port can be configured to accept RGB (RGBHV, RGBs) or
component video (bi- or tri-level) signals. The default setting is for RGB. The
on the next page shows the pinouts for each format type on the 15-pin HD (VGA)
connector. The 15-pin HD supports EDID emulation.
DSC 301 HD
DSC 301 HD
2 3
2 3
AUDIO
AUDIO
D
Control and Power
Remote RS-232 control port
F
Power receptacle
G
DSC 301 HD • Introduction
REMOTE
REMOTE
RS-232
RS-232
Tx Rx G
OUTPUT
Tx Rx G
OUTPUT
E F
table
5