Endress+Hauser Levelflex FMP55 Operating Instructions Manual page 180

Operating menu
Operating time
Navigation
Description
User interface
Additional information
Last backup
Navigation
Description
User interface
Configuration management
Navigation
Description
Selection
Factory setting
180
"Configuration backup display" submenu
This submenu is only visible if a display module is connected to the device.
The configuration of the device can be saved to the display module at a certain point of
time (backup). The saved configurateion can be restored to the device if required, e.g. in
order to bring the device back into a defined state. The configuration can also be
transferred to a different device of the same type using the display module.
Configurations can only be exchanged between devices which are in the same
operating mode (see the Operating mode parameter (→  129)).
Navigation  Setup → Advanced setup → Conf.backup disp
 Setup → Advanced setup → Conf.backup disp → Operating time
Indicates how long the device has been in operation.
Days (d), hours (h), minutes (m), seconds (s)
Maximum time
9 999 d ( ≈ 27 years)
 Setup → Advanced setup → Conf.backup disp → Last backup
Indicates when the last data backup was saved to the display module.
Days (d), hours (h), minutes (m), seconds (s)
 Setup → Advanced setup → Conf.backup disp → Config. managem.
Select action for managing the device data in the display module.
• Cancel
• Execute backup
• Restore
• Duplicate
• Compare
• Clear backup data
• Display incompatible
Cancel
Levelflex FMP55 FOUNDATION Fieldbus
Endress+Hauser
