Specifying A Policy For Interface Pbr; Displaying And Maintaining Pbr; Pbr Configuration Examples; Packet Type-Based Local Pbr Configuration Example - HPE FlexNetwork 5510 HI Series Configuration Manual

Specifying a policy for interface PBR

You can specify only one policy for interface PBR and must make sure the specified policy already
exists.
Before you can apply a new policy to an interface, you must first remove the current policy from the
interface.
You can apply a policy to multiple interfaces.
To specify a policy for interface PBR on an interface:
Step
Enter system
1.
view.
Enter interface
2.
view.
Specify a policy
3.
for interface
PBR.

Displaying and maintaining PBR

Execute display commands in any view and reset commands in user view.
Task
Display PBR policy information.
Display PBR configuration.
Display local PBR configuration and statistics.
Display interface PBR configuration and
statistics.
Clear PBR statistics.

PBR configuration examples

Packet type-based local PBR configuration example

Network requirements
As shown in
Configure PBR on Switch A to forward all TCP packets to the next hop 1.1.2.2 (Switch B).
Command
system-view
interface interface-type interface-number
ip policy-based-route policy-name
Figure 87, Switch B and Switch C cannot reach each other.
Remarks
N/A
N/A
By default, no interface policy is
applied to an interface.
Command
display ip policy-based-route [ policy policy-name ]
display ip policy-based-route setup
display ip policy-based-route local [ slot slot-number ]
display ip policy-based-route interface interface-type
interface-number [ slot slot-number ]
reset ip policy-based-route statistics [ policy
policy-name ]
373