Chmsl Housing – Concorde/Lhs; Chmsl And Applique Housing – Intrepid; Chmsl Housing – 300M - Chrysler 2000 LHS Owner's Manual

8L - 22 LAMPS
REMOVAL AND INSTALLATION (Continued)
FRONT PARKING, SIDE MARKER, AND TURN
SIGNAL LAMP HOUSING – CONCORDE/300M
REMOVAL
(1) Remove headlamp housing to access lamp
housing.
(2) Rotate and pull socket from lamp housing.
(3) Disconnect fastener attaching lamp housing to
fascia (Fig. 12).
(4) Remove lamp housing from vehicle.
Fig. 12 Front Parking, Side Marker, and Turn Signal
Lamp Housing
INSTALLATION
(1) Place lamp housing in position on fascia.
(2) Install lamp fastener.
(3) Install bulb socket in lamp.
(4) Verify lamp operation.
(5) Install headlamp housing.
CHMSL HOUSING – CONCORDE/LHS
REMOVAL
(1) Release decklid latch and open decklid.
(2) From under rear
CHMSL wire connector from body harness.
(3) Remove rear shelf upper panel.
(4) Remove fasteners attaching the CHMSL to rear
shelf upper panel (Fig. 13).
(5) Remove CHMSL from rear shelf upper panel.
INSTALLATION
(1) Place CHMSL in position on rear shelf upper
panel.
(2) Install fasteners to attach CHMSL to rear shelf
upper panel.
(3) Install rear shelf upper panel.
(4) Connect CHMSL wire connector to body har-
ness.
(5) Verify CHMSL operation.
shelf panel, disconnect
Fig. 13 CHMSL – Rear Shelf
1 – REAR SHELF TRIM PANEL
2 – ATTACHING SCREWS
CHMSL AND APPLIQUE HOUSING – INTREPID
REMOVAL
(1) Release decklid latch and open decklid.
(2) Remove decklid cover.
(3) Disconnect CHMSL wire connector from body
harness (Fig. 14).
(4) Remove fasteners attaching CHMSL and appli-
que to the decklid.
(5) Remove CHMSL from decklid.
INSTALLATION
(1) Place CHMSL in position on decklid.
(2) Install fasteners attaching CHMSL and appli-
que to decklid.
(3) Connect CHMSL wire connector to body har-
ness.
(4) Verify CHMSL operation.
(5) Install decklid cover.
CHMSL HOUSING – 300M
REMOVAL
(1) Release decklid latch and open decklid.
(2) Remove decklid cover.
(3) Disconnect CHMSL wire connector from body
harness (Fig. 15).
(4) Remove fasteners attaching CHMSL to the
decklid.
(5) Remove CHMSL from decklid.
INSTALLATION
(1) Place CHMSL in position on decklid.
(2) Install fasteners attaching CHMSL to decklid.
(3) Connect CHMSL wire connector to body har-
ness.
LH