Windshield Washer Nozzles; Washer Reservoir - Chrysler 2000 LHS Owner's Manual

8K - 14 WIPER AND WASHER SYSTEMS
REMOVAL AND INSTALLATION (Continued)
(6) Disconnect hose clips from hood, tower to tower
beam, and fender beam.
(7) Disconnect washer hose from top of reservoir
and from washer pump discharge port.
(8) Carefully pull washer hose up through engine
compartment.
INSTALLATION
For installation, reverse the above procedures. Be
sure to test and check system for leaks and pinched
or kinked hoses.

WINDSHIELD WASHER NOZZLES

REMOVAL
(1) Using a plastic body filler spreader or equiva-
lent (credit card), gently place it underneath the
front of the washer nozzle. Be careful not to damage
the hood seal underneath the nozzle.
(2) Rock the nozzle back and forth slightly to
release it from the hood panel.
(3) Pull the nozzle out of the hood panel far
enough to disconnect the hose.
Fig. 8 Windshield Washer Nozzle
1 – HOOD
2 – ADJUST WITH A SAFETY PIN
3 – NOZZLE
INSTALLATION
(1) For installation, reverse the above procedures.
(2) After connecting hose, check for proper system
function and to assure leak free connections by actuat-
ing the washer system switch from inside of vehicle.

WASHER RESERVOIR

REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post.
(2) Hoist vehicle.
(3) Remove front fascia as necessary (left side only
and use a 2x4 to prop left edge of fascia away from
body). Refer to Group 23, Body for Removal and
Installation procedures.
(4) Disconnect the wire connectors from the reser-
voir pump and float sensor.
(5) Disconnect the washer hose and block the liq-
uid outlet to prevent the liquid from running out of
the reservoir.
(6) Reach up behind the washer reservoir and pull
the filler tube off the rear of the reservoir.
(7) Remove four mounting bolts to washer reser-
voir (Fig. 9).
Fig. 9 Washer Reservoir Removal
1 – WASHER RESERVOIR FILLER TUBE
2 – WASHER RESERVOIR
(8) Remove washer reservoir from vehicle.
(9) Transfer fluid level sensor, pump, and washer
fluid to new reservoir (Fig. 10).
INSTALLATION
(1) Connect washer hose, filler tube, and wire con-
nectors to reservoir.
(2) Install reservoir retaining bolts. Torque bolts to
80 to 124 in. lbs. (9 to 14 N·m).
(3) Reconnect the negative battery cable remote
terminal.
WASHER RESERVOIR (INTREPID)
REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post.
LH