Clock; Cluster And Bezel; Cluster Lamps - Chrysler 2000 LHS Owner's Manual

LH
REMOVAL AND INSTALLATION (Continued)
INSTALLATION
(1) Position mount ring to the instrument panel
and feed the wires through ring. Index the cap and
the mount ring with the index tab at 9 o'clock to the
key in the instrument panel. Install the ring.
(2) Connect wires to base. Orient base alignment
rib at 11 o'clock to mate the groove in mount ring at
the same location
(3) Push base into the bezel till it locks.
(4) Install cigar lighter cap and check operation of
element.
Fig. 12 Tool For Cigar Lighter / Power Outlet
1 – 2.5MM (3/32 INS.)
2 – WELD
3 – 100MM (4 INS.)
4 – 22.25 TO 22.45MM (7/8 TO 57/64 INS.)

CLOCK

REMOVAL
(1) Open hood.
(2) Disconnect and isolate the negative battery
remote cable.
(3) Using a trim stick (special tool #C-4755), gently
pry out instrument panel air distribution outlet bezel
that retains the analog clock.
(4) Disconnect the one wire connector to the clock.
(5) Remove bezel from vehicle.
(6) On the bench, remove two retaining screws to
analog clock and remove from bezel (Fig. 13).
INSTALLATION
For installation, reverse the above procedures.

CLUSTER AND BEZEL

REMOVAL
To service any instrument cluster component, the
instrument cluster must be removed from the instru-
ment panel. Use the following procedure:
Removal
INSTRUMENT PANEL SYSTEMS
Fig. 13 Analog Clock Removal
1 – WIRE HARNESS CONNECTOR
2 – CLOCK LAMP
3 – RETAINING SCREWS
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post
(Fig. 22).
(2) Remove the instrument panel left end cap.
(3) Remove steering column shroud cover.
(4) Tilt the steering column down into the lowest
position.
(5) Remove one screw (LHS / 300M) to cluster
bezel
(6) Remove the items to expose bezel mounting
screws. Items vary depending on model.
(7) Remove two screws over upper cluster bezel in
instrument panel brow area and all remaining
attaching screws (four on Intrepid, LHS, and 300M,
and five on Concorde).
(8) Using a trim stick (special tool #C-4755), gently
pry out on the instrument panel cluster bezel, discon-
nect headlamp switch connector, and remove.
(9) Remove the instrument cluster screws.
NOTE: Tilt steering wheel down to gain access for
instrument cluster removal.
(10) Remove the instrument cluster from panel.
The instrument panel wiring harness connectors are
self-aligning, mounted directly to the rear panel. A
force of approximately 9 kilograms (30 lbs.) will be
required to disengage the cluster from the connectors
and upper clips. In the lower corners of the cluster
housing, tabs have been provided so that a "hook"
type device can be used to aid in removal.
INSTALLATION
For installation, reverse the above procedures.

CLUSTER LAMPS

To service instrument cluster lamps, the cluster
must be removed from the instrument panel. Refer to
8E - 11