Chrysler 2000 LHS Owner's Manual page 258

Table of Contents

Advertisement

LH
REMOVAL AND INSTALLATION (Continued)
Fig. 15 Camshaft Position Sensor
1 – SHORT RUNNER VALVE
2 – CAMSHAFT POSITION SENSOR
3 – MANIFOLD TUNING VALVE
REMOVAL
(1) Disconnect the negative battery cable.
(2) Remove the upper intake plenum, refer to the
Intake System section.
(3) Disconnect electrical connector from sensor.
(4) Remove camshaft position sensor screw.
(5) Pull sensor up out of the timing belt housing
cover.
INSTALLATION
If the removed sensor is reinstalled, com-
pletely remove the old spacer from the sensor
face. Attach a NEW SPACER to the face of the
sensor before installation. If installing a new sen-
sor, confirm that the paper spacer is attached to the
face (Fig. 16).
Fig. 16 Paper Spacer—3.2/3.5L Engine
1 – CAMSHAFT POSITION SENSOR
2 – PAPER SPACER
(1) Install sensor in the timing belt housing and
push sensor down until contact is made with the
camshaft sprocket. While holding the sensor in this
position, install and tighten the retaining bolt to 12
N·m (105 in. lbs.) torque.
(2) Attach electrical connector to sensor.
(3) Install the upper intake plenum, refer to the
Intake System section.
(4) Connect the negative battery cable.
CRANKSHAFT POSITION SENSOR
The crankshaft sensor is located on the passengers
side of the transmission housing, above the differen-
tial housing (Fig. 17). The bottom of the sensor sits
above the drive plate.
Fig. 17 Crankshaft Position Sensor
1 – CRANKSHAFT POSITION SENSOR
REMOVAL
(1) Disconnect electrical connector from crankshaft
position sensor.
(2) Remove sensor mounting screw. Remove sensor.
INSTALLATION
(1) Install sensor and push sensor down until con-
tact is made with the transmission case. While hold-
ing the sensor in this position, install and tighten the
retaining bolt to 12 N·m (105 in. lbs.) torque.
(2) Connect electrical connector to crankshaft posi-
tion sensor.
KNOCK SENSOR
The engine uses one knock sensor(s). The sensor is
bolted into the cylinder block, directly below the
intake manifold.
IGNITION SYSTEM
8D - 7

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

300mConcordeIntrepid

Table of Contents