Brake Tube Fittings; Transmission Controller Mounting; 25-Way Cab Connector Lock - Chrysler 2000 LHS Owner's Manual

5 - 70 BRAKES
REMOVAL AND INSTALLATION (Continued)
Fig. 13 Brake Pedal Holding Tool Installed
1 – CLUTCH PEDAL (IF EQUIPPED WITH MANUAL TRANSAXLE)
2 – THROTTLE PEDAL
3 – BRAKE PEDAL HOLDING TOOL
4 – STEERING WHEEL
5 – DRIVER'S SEAT
6 – BRAKE PEDAL
Fig. 14 Transmission Controller Mounting
1 – POWER DISTRIBUTION CENTER
2 – WASHER BOTTLE NECK
3 – TRANSMISSION CONTROLLER MOUNTING BOLT AND NUT
CAUTION: Do not apply a 12-volt power source to
any terminals of the 25-way HCU connector when
disconnected from the CAB.
(10) Disconnect the 25-way wiring harness connec-
tor from the CAB using the following procedure.
Grasp the lock on the 25-way connector (Fig. 16), and
pull it up from the connector as far as possible. This
will unlock and raise the 25-way connector out of the
socket on the CAB.
Fig. 15 Brake Tube Fittings
1 – CROW FOOT WRENCH
2 – PRIMARY AND SECONDARY BRAKE TUBES FROM MASTER
CYLINDER
3 – CHASSIS BRAKE TUBES
Fig. 16 25-Way CAB Connector Lock
1 – 25–WAY CAB CONNECTOR
2 – CONNECTOR LOCK
(11) Raise vehicle on jackstands or centered on a
hoist. See Hoisting in the Lubrication and Mainte-
nance section of this manual.
(12) Remove the left front tire and wheel assembly.
(13) Remove fasteners securing the inner fender
splash shield in place. Move the splash shield out of
the way.
(14) Remove the 3 bolts attaching the ICU to the
mounting bracket.
(15) Remove the ICU from its mounting bracket.
Then, remove the ICU from the vehicle by pulling it
out around the left side of the mounting bracket,
then through the wheel well.
LH