Instrument Panel Speaker (Infinity); Radio/Tape/Cd Player; Rear Door Speakers (Infinity Ll); Rear Shelf Speaker - Chrysler 2000 LHS Owner's Manual

8F - 18 AUDIO SYSTEMS
REMOVAL AND INSTALLATION (Continued)
4 DISC IN-DASH CD CHANGER
REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post.
(2) Remove ash receiver (if applicable).
(3) Using a trim stick (special tool #C-4755), gently
pry out on center trim bezel. Disconnect wiring con-
nectors to HVAC controls, cigar lighter/auxiliary
power outlet and traction control switch.
(4) Remove instrument panel center trim bezel.
(5) Remove two retaining screws to in-dash CD
changer.
(6) Pull CD changer out of instrument panel, dis-
connect wiring and remove from vehicle.
INSTALLATION
For installation, reverse the above procedures

INSTRUMENT PANEL SPEAKER (INFINITY)

CAUTION: Do not operate the radio with speaker
leads detached. Damage to the output devices may
result.
REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post
(Fig. 6).
(2) Remove instrument panel top cover: Refer to
Group 8E, Instrument Panel Systems for Removal
and Installation procedures.
(3) Remove two retaining screws to center speaker
and disconnect wiring connector.
(4) Remove speaker from vehicle.
INSTALLATION
For installation, reverse the above procedures.

RADIO/TAPE/CD PLAYER

REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post
(Fig. 6).
(2) Remove instrument panel center trim bezel.
Refer to Group 8E, Instrument Panel and Systems
for Removal and Installation procedures.
(3) Remove four radio mounting screws.
(4) Pull radio from panel and disconnect wiring,
ground strap, wires and antenna lead from radio.
(5) Remove radio from vehicle.
INSTALLATION
For installation, reverse the above procedures.

REAR DOOR SPEAKERS (INFINITY ll)

REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post
(Fig. 6).
(2) Open rear door.
(3) Using a trim stick (special tool #C-4755), care-
fully pry speaker grille away from door trim panel.
(4) Remove two speaker retaining screws.
(5) Pull speaker away from door and disconnect
wiring.
Fig. 8 Rear Door Speaker
1 – DOOR SPEAKER
INSTALLATION
For installation, reverse the above procedures.

REAR SHELF SPEAKER

CAUTION: Do not operate the radio with speaker
leads detached. Damage to the output devices may
result.
REMOVAL
(1) Open hood and disconnect the negative battery
cable remote terminal from the remote battery post
(Fig. 6).
(2) Remove rear shelf panel, refer to Group 23,
Body for Removal and Installation procedures.
(3) Remove four retaining screws.
(4) Remove speaker and disconnect wire connector.
The wire connectors can be accessed through the
trunk.
LH