Chrysler 2000 LHS Owner's Manual page 107

3 - 16 DIFFERENTIAL AND DRIVELINE
DISASSEMBLY AND ASSEMBLY (Continued)
(7) Clamp sealing boot onto outer C/V joint hous-
ing using Crimper, Special Tool C-4975 and the fol-
lowing procedure. Place crimping tool C- 4975 over
bridge of clamp (Fig. 38). Tighten nut on crimping
tool C-4975 until jaws on tool are closed completely
together, face to face (Fig. 39).
Fig. 38 Crimping Tool Installed On Sealing Boot
1 – SPECIAL TOOL C-4975
2 – SEALING BOOT
3 – CLAMP BRIDGE
(8) Install the driveshaft requiring boot replace-
ment back on the vehicle. See "Driveshaft Removal
and Installation" in this section of the service man-
ual for the required driveshaft installation procedure.
SPECIFICATIONS
TORQUE SPECIFICATIONS
DESCRIPTION
Caliper To Knuckle Bolts . . . . 19 N·m (168 in. lbs.)
Driveshaft Nut . . . . . . . . . . . 150 N·m (105 ft. lbs.)
Front Wheel Lug Nuts . . . . . . 135 N·m (100 ft. lbs.)
Knuckle To Strut Bolt Nuts . . 169 N·m (125 ft. lbs.)
Tie Rod End To Knuckle . . . . . . 61 N·m (45 ft. lbs.)
Clamp
TORQUE
Fig. 39 Sealing Boot Retaining Clamp Installed
1 – BOOT CLAMP
2 – SPECIAL TOOL C-4975
3 – SEALING BOOT
4 – OUTER C/V JOINT
SPECIAL TOOLS
DRIVESHAFT
Boot Clamp Installer C-4975A
Puller 6790
LH