Wheel Speed Sensor (Rear); Speed Sensor Head Attachment To Steering Knuckle - Chrysler 2000 LHS Owner's Manual

5 - 72 BRAKES
REMOVAL AND INSTALLATION (Continued)
Fig. 18 Speed Sensor Head Attachment To Steering
1 – SENSOR EAR
2 – PUNCH
3 – SPEED SENSOR HEAD
cable grommet and retainer bracket on the inner
fender of the vehicle and install and securely tighten
attaching bolt.
CAUTION: When installing the wheel speed sensor
cable routing bracket on the strut, the speed sensor
cable must be looped upward as shown (Fig. 17). If
speed sensor cable is not routed in this direction it
may rub, damaging the speed sensor cable.
(3) Install the speed sensor cable routing bracket
on the steering knuckle. Install and tighten routing
bracket mounting bolt to a torque of 12 N·m (105 in.
lbs.)
(4) Apply a small amount of High Temperature
Multipurpose grease to the sensor head before instal-
lation. Install speed sensor head on steering knuckle.
Install the speed sensor head attaching screw and
tighten to a torque of 7 N·m (60 in. lbs.).
(5) Install the wheel and tire assembly on vehicle.
(6) Lower the vehicle to the ground.
(7) Road test vehicle to ensure proper operation of
the base and ABS systems.

WHEEL SPEED SENSOR (REAR)

REMOVAL
NOTE: When removing rear wheel speed sensor
from vehicle, access to the wire harness connector
is through the passenger compartment of the vehi-
cle.
Knuckle
(1) Remove the rear seat cushion, and the rear
seat back, from the interior of the car. Refer to Seats
in the Body section of this manual for the required
procedure to be used for this vehicle.
(2) Disconnect the wheel speed sensor cable from
the wire harness.
(3) Raise vehicle on jack stands or centered on a
frame contact type hoist. See Hoisting in the Lubri-
cation and Maintenance section of this manual for
the required lifting procedure to be used for this
vehicle.
(4) Remove the rear wheel and tire assembly from
the vehicle.
(5) Remove the grommet from the floor pan, along
with the end of the cable that fastens to the wire
harness.
(6) Remove the sensor cable from the routing
bracket attached to the strut tower flange.
(7) Remove the wheel speed sensor head and rout-
ing bracket from the disc brake caliper adapter by
removing the bolt, then the sensor (Fig. 19).
Fig. 19 Wheel Speed Sensor At Adapter
1 – STABILIZER BAR LINK
2 – STABILIZER BAR
3 – LATERAL LINK
4 – BOLT
5 – WHEEL SPEED SENSOR
6 – STRUT ASSEMBLY
7 – NUT
INSTALLATION
(1) Install rear wheel speed sensor and routing
bracket into brake caliper adapter. Install head
attaching bolt (Fig. 19) and tighten to 7 N·m (60 in.
lbs.).
(2) Install the sensor cable to the routing bracket
attached to the strut tower flange.
(3) Guide the cable through the hole in the floor
pan and install the grommet.
LH