Reinforcement Attachment To Vehicle; Master Cylinder Positioning; Wiper Crank Lever Positioning - Chrysler 2000 LHS Owner's Manual

5 - 28 BRAKES
REMOVAL AND INSTALLATION (Continued)
Fig. 44 Reinforcement Attachment To Vehicle
1 – RIGHT STRUT TOWER
2 – WIPER MODULE
3 – LEFT STRUT TOWER
4 – ATTACHING BOLTS
5 – ATTACHING BOLT
6 – REINFORCEMENT
7 – ATTACHING BOLTS
Fig. 45 Master Cylinder Mounting
1 – MASTER CYLINDER MOUNTING NUTS
2 – POWER BRAKE BOOSTER
3 – MASTER CYLINDER
it is not to be reused, replace only with a new
retainer clip.
(12) Remove the four nuts that attach the vacuum
booster to the vehicle dash panel. Nuts are accessible
from under the dash panel in the area of the steering
column and pedal bracket.
(13) Rotate the windshield wiper motor crank
lever until the crank lever points in the 12 o'clock
position (Fig. 47).
(14) Slide the vacuum booster out of the dash
panel, and remove from vehicle.
CAUTION: Do not attempt to disassemble the vac-
uum booster. It is serviced ONLY as a complete
assembly.
Fig. 46 Master Cylinder Positioning
1 – BOOSTER
2 – MASTER CYLINDER
3 – ENGINE CYLINDER HEAD COVER
Fig. 47 Wiper Crank Lever Positioning
1 – WIPER MOTOR CRANK LEVER
2 – BRAKE BOOSTER
INSTALLATION
(1) Position vacuum booster on dash panel.
(2) Install and tighten the 4 power brake booster
to dash panel mounting nuts to 29 N·m (250 in. lbs.)
torque.
(3) Using lubriplate, or equivalent, coat the bear-
ing surface of brake pedal pin.
(4) Connect vacuum booster input rod to brake
pedal pin and install a NEW retainer clip. Use only
a new retainer clip DO NOT USE the old clip.
NOTE: Before installing master cylinder, reposition
under hood wiring harness above master cylinder
mounting studs (Fig. 46), in front of booster.
LH