Seat Adjuster; Seat Switch - Chrysler 2000 LHS Owner's Manual

8R - 4 POWER SEAT SYSTEMS
REMOVAL AND INSTALLATION
SEAT ASSEMBLY
Refer to Group 23–Body, Front Seat Removal and
Installation.

SEAT ADJUSTER

REMOVAL
(1) Seat removed from vehicle. Using a clean area
to place seat.
(2) Remove two seat back mounting screws and
also remove two seat back recliner screws (Fig. 4).
Fig. 4 Seat Adjuster Removal
1 – TRACK TO SEAT CUSHION SCREWS
2 – FRONT
3 – SEAT BACK RECLINER SCREWS
4 – VIEWED FROM TOP OF TRACK
(3) Remove four seat adjuster mounting screws
from cushion pan.
(4) Remove adjuster from seat.
INSTALLATION
For installation, reverse the above procedure.

SEAT SWITCH

REMOVAL
(1) Open hood, disconnect and isolate the negative
battery cable remote terminal from the remote bat-
tery post (Fig. 5).
Fig. 5 Negative Battery Cable Remote Terminal
1 – RIGHT STRUT TOWER
2 – AIR CLEANER INLET TUBE
3 – REMOTE TERMINAL
(2) Remove cushion side shield (Fig. 6).
Fig. 6 Cushion Side Shield
(3) Disconnect wiring from switch.
(4) Remove knobs from the switch.
(5) Remove four switch attaching screws.
(6) Remove switch from cushion side shield
INSTALLATION
For installation, reverse the above procedure.
LH