Changing Only The It Password - Logicube SuperSonix-NG User Manual

1. Connect a USB keyboard to one of the two USB ports in front of the
2. Once logicube prompt appears, type the following commands, one line
3. The following prompt will appear:
4. Type the current password (by default, "logicube" without the quotes)
5. Type a new password then press the Enter key. The following prompt
6. Type the new password again then press the Enter key. The following
7. Next, type the following command:
8. The following prompt will appear:
9. Type the same password you used in step 5 above. The following
10. Type the same password again, then press the Enter key. The Logicube
11. Type the following command then press the Enter key:
12. Press the following key combinations to go back to the Graphical User

6.0.3 Changing only the it password

For the username: it
Logicube SuperSonix-NG™ User's Manual
SuperSonix-NG then use the following key combinations: Alt+2 then
Alt+Shift+Enter.
at a time (Press the Enter key after each command/line):
sudo mount -o remount,rw /
passwd
Changing password for logicube.
(current) UNIX password:
then press the Enter key. The following prompt will appear:
Enter new UNIX password:
will appear:
Retype new UNIX password:
response should appear:
passwd: password updated successfully
sudo smbpasswd logicube
New SMB password:
prompt will appear:
Retype new SMB password:
prompt should appear.
sudo mount -o remount,ro /
Interface: Alt+1
DEFAULT PASSWORDS
66