Profiles - Logicube SuperSonix-NG User Manual

5.8.1 Profiles

This screen shows all profiles for the SuperSonix-NG. There are three options in
this screen:

New – Allows the user to create a new profile name.

Save – Saves the selected profile.

Load – Loads the selected profile.
Profiles allow users to create different profiles or configurations. The profile can
then be saved. When a profile is loaded using the Load icon, the SuperSonix-NG
will load that configuration during its boot process.
For example, if the user wants the SuperSonix-NG to always boot up with the
default Clone mode of Image to Drive:
1. Turn the SuperSonix-NG off then back on. This will reset all settings to
its default configuration. This is an important step to help ensure only
the changes desired will be the changes saved.
2. Go to the Clone screen and set the Mode to 'Image to Drive'.
3. In the System Settings, go to Profiles and tap the New icon
4. Type a name for this profile. For example, ImageToDrive and tap the OK
icon. The profile name should appear on the screen.
Logicube SuperSonix-NG™ User's Manual
The SuperSonix-NG will boot with the profile that has an asterisk
(*) next to the name.
Profiles can be copied from one Falcon to another using the
Command Line Interface. Profiles can also be backed up to a USB
flash drive and restored if needed. More information including
detailed step-by-step instructions can be found in
TYPES OF OPERATIONS
Section 8.7.
55