Step-By-Step Instructions - Wipe - Logicube SuperSonix-NG User Manual

3.3.1 Step-by-step instructions – Wipe
1. Select Wipe from the types of operation on the left side.
2. Tap the Target icon and select one or more drives then tap the OK icon.
3. Tap the Settings icon and choose the type of wipe to be performed
(Secure Erase, Wipe Patterns, and/or Format). If Wipe Patterns is
selected, choose the type of Wipe Pattern to perform (DoD or Custom).
4. If the drive has an HPA or DCO area that needs to be wiped, tap the
HPA/DCO icon and select Yes to wipe the HPA/DCO area of the drive.
OPTIONAL for Wipe Pattern mode: Tap the Passes icon to edit the number
of passes and what gets written on each pass.
5. If the drive needs to be formatted, tap the Settings icon to change the
Format settings then tap the OK icon.
6. Tap the Start icon to start the wipe task. The SuperSonix-NG will
perform a Secure Erase first (if selected), then a Wipe Pattern (if
selected), then finally a Format (if selected).
7. When finished, the status will show "COMPLETED". At this point, it is
recommended to tap Reset Task to reset the task so the drive bays
properly reset and not show as being used or assigned for other tasks.
Logicube SuperSonix-NG™ User's Manual
It is recommended to use the same capacity drive per
task. When smaller capacity drives are wiped together
with larger capacity drives, the smaller drives will finish
first. However, the drive bays will not be available until
the entire task is finished.
QUICK START
19