6: Security - Changing The Default Passwords; Changing The Default Passwords - Introduction; Changing Both The Logicube And It Passwords - Logicube SuperSonix-NG User Manual

6.0 Changing the default passwords - Introduction

The SuperSonix-NG comes with default accounts created. It is highly recommended to change
the default passwords for security purposes.

logicube

it
If the new password(s) cannot be remembered, a system recovery must be
performed to reset the passwords back to the default values. Contact Logicube
Technical Support for instructions on how to perform a system recovery.

6.0.1 Changing both the logicube and it passwords

To change both the "logicube" and "it" passwords, follow these steps:
1. Connect a USB keyboard to one of the two USB ports in front of the
2. Once logicube prompt appears, type the following commands, one line
3. The following prompt will appear:
4. Type the current password for the "logicube" account (the default
5. Type a new password then press the Enter key. The following prompt
6. Type the new password again then press the Enter key. The following
®
-NG User's Manual
Logicube SuperSonix
6: Security – Changing the default passwords
SuperSonix-NG then use the following key combinations: Alt+2 then
Alt+Shift+Enter.
at a time (Press the Enter key after each command/line):
sudo mount -o remount,rw /
passwd
Changing password for logicube.
(current) UNIX password:
password for this account is "logicube") then press the Enter key. The
following prompt will appear:
Enter new UNIX password:
will appear:
Retype new UNIX password:
response should appear:
passwd: password updated successfully
64