Clever Clone Partition Resize Settings Or Mirror Clone Advanced Settings - Logicube SuperSonix-NG User Manual

Logicube SuperSonix-NG™ User's Manual
From this screen, you can choose Mode to change the mode.
Choose between Mirror or Clever.

CLEVER – Clones only sectors with data, skips blank
sectors, then adjusts the partition to fit the drive.

MIRROR – Performs a bit-for-bit copy of the Master
drive or image.
4.3.4.2 Clever Clone Partition Resize Settings or
Mirror Clone Advanced Settings
The Partition Resize Settings or Mirror Settings window will
show the different clone settings available based on which
clone method (above) was chosen.

If Clever was chosen, the following screen will appear
showing a list of partitions seen on the Master drive.
Tap Settings to bring up the Clever Clone Partition
Resize window. This screen displays each partition on
the selected Master drive, the Filesystem, and for each
partition, a resize percentage bar to set the percentage
to resize each partition.
Setting the slider/percentage to 0% will instruct the SuperSonix-
NG to keep the same partition size.
The percentage value, when set from 1 to 100 will determine
what percentage of the Target drive(s) will be used. For example,
setting the percentage value to 100% would instruct the
SuperSonix-NG to use the entire Target drive for that partition.
When attempting to clone to a Target drive that is smaller in
capacity than the Master drive, the partitions on the Master drive
need to be adjusted to be no more than the same size of the
Target drives. Please see
cloning to smaller capacity drives.

If Mirror was chosen, a screen will appear showing a
percentage of the Master drive to copy. By default, it
will be set to 100% to copy the entire Master drive.
Section 3.1.2 for more information on
CLONE
32