Table of Contents
Advertisement
If you specify an interface type but do not specify an interface number, this command displays
information about all interfaces of that type.
If you specify both the interface type and interface number, this command displays information about
the specified interface.
Examples
# Display information about Layer 2 interface GigabitEthernet 1/0/1.
<Sysname> display interface gigabitethernet 1/0/1
GigabitEthernet1/0/1
Current state: UP
Line protocol state: UP
IP packet frame type: Ethernet II, hardware address: 0023-8927-ad7e
Description: GigabitEthernet1/0/1 Interface
Bandwidth: 1000000kbps
Loopback is not set
Media type is twisted pair
Port hardware type is 1000_BASE_T
1000Mbps-speed mode, full-duplex mode
Link speed type is autonegotiation, link duplex type is autonegotiation
Flow-control is not enabled
The maximum frame length is 10000
Allow jumbo frames to pass
Broadcast max-ratio: 100%
Multicast max-ratio: 100%
Unicast max-ratio: 100%
PVID: 1
MDI type: automdix
Port link-type: Access
Tagged VLANs:
UnTagged VLANs: 1
Port priority: 0
Last link flapping: Never
Last clearing of counters: Never
Peak input rate: 14 bytes/sec, at 2013-01-01 06:32:27
Peak output rate: 552 bytes/sec, at 2013-01-01 06:32:27
Last 300 second input: 0 packets/sec 13 bytes/sec 0%
Last 300 second output: 1 packets/sec 245 bytes/sec 0%
Input (total):
0 unicasts, 2 broadcasts, 1183 multicasts, 0 pauses
Input (normal):
0 unicasts, 2 broadcasts, 1183 multicasts, 0 pauses
Input:
0 input errors, 0 runts, 0 giants, 0 throttles
0 CRC, 0 frame, - overruns, 0 aborts
- ignored, - parity errors
Output (total): 66479 packets, 14123537 bytes
592 unicasts, 35505 broadcasts, 30382 multicasts, 0 pauses
Output (normal): 66479 packets, - bytes
592 unicasts, 35505 broadcasts, 30382 multicasts, 0 pauses
Output: 0 output errors, - underruns, - buffer failures
None
1185 packets, 343696 bytes
1185 packets, - bytes
8
Advertisement
Table of Contents
