display mvrp state
Use display mvrp state to display the MVRP state of a port in a VLAN.
Syntax
display mvrp state interface interface-type interface-number vlan vlan-id
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface interface-type interface-number: Specifies a port by its type and number.
vlan vlan-id: Specifies a VLAN by its VLAN ID in the range of 1 to 4094.
Examples
# Display the MVRP state of GigabitEthernet 1/0/1 in VLAN 2.
<Sysname> display mvrp state interface gigabitethernet 1/0/1 vlan 2
MVRP state of VLAN 2 on port GE1/0/1:
Port
------------------------ ------ ----------- -----------
GE1/0/1
Table 52 Command output
Field
MVRP state of VLAN 2
on port GE1/0/1
App-state
Reg-state
VLAN
App-state
2
VP
Description
MVRP state of GigabitEthernet 1/0/1 in VLAN 2.
State of the attribute that the local participant declares to its peer participant:
•
VO—Very anxious observer.
•
VP—Very anxious passive.
•
VN—Very anxious new.
•
AN—Anxious new.
•
AA—Anxious active.
•
QA—Quiet active.
•
LA—Leaving active.
•
AO—Anxious observer.
•
QO—Quiet observer.
•
AP—Anxious passive.
•
QP—Quiet passive.
•
LO—Leaving observer.
Registration state of the attribute declared by the peer participant on the local
participant:
•
IN—Registered.
•
LV—Previously registered, but now being unregistered.
•
MT—Not registered.
232
Reg-state
IN