Table of Contents
Advertisement
Views
Ethernet interface view
Predefined user roles
network-admin
Parameters
10: Sets the interface speed to 10 Mbps.
100: Sets the interface speed to 100 Mbps.
1000: Sets the interface speed to 1000 Mbps.
10000: Sets the interface speed to 10000 Mbps.
auto: Enables the interface to negotiate a speed with its peer.
Usage guidelines
A GE SFP interface supports only keywords 100, 1000, and auto.
A GE copper port supports only keywords 10, 100, 1000, and auto.
A 10-GE SFP+ interface supports only keywords 1000, 10000, and auto.
A 10-GE copper port supports only keywords 100, 1000, 10000, and auto.
Interfaces on an HPE 5130/5510 10GbE SFP+ 2-port Module (JH157A) or HPE 5130/5510
10GBASE-T 2-port Module (JH156A) interface card support only the 10000 keyword.
For a fiber port, use the speed command to set its speed to match the rate of a transceiver module.
Examples
# Configure GigabitEthernet 1/0/1 to autonegotiate the speed.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] speed auto
Related commands
speed auto
speed auto downgrade
Use speed auto downgrade to enable automatic negotiation for speed downgrading.
Use undo speed auto downgrade to disable automatic negotiation for speed downgrading.
Syntax
speed auto downgrade
undo speed auto downgrade
Default
Automatic negotiation for speed downgrading is enabled.
Views
Ethernet interface view
Predefined user roles
network-admin
26
Advertisement
Table of Contents
