Table of Contents
Advertisement
Syntax
display
link-aggregation
interface-number ] ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
bridge-aggregation: Specifies Layer 2 aggregate interfaces.
interface-number: Specifies an existing aggregate interface number.
Usage guidelines
If you do not specify the interface keyword, the command displays the global link-aggregation load
sharing modes.
If you specify the interface keyword but do not specify an interface, the command displays all
group-specific load sharing modes.
If you specify the bridge-aggregation interface-number option, the command displays the load
sharing mode of the specified aggregation group.
The bridge-aggregation keyword is available only when Layer 2 aggregate interfaces exist on the
device.
Examples
# Display the default global link-aggregation load sharing modes.
<Sysname> display link-aggregation load-sharing mode
Link-Aggregation Load-Sharing Algorithm:
Default
Link-Aggregation Load-Sharing Seed:
Default
Link-Aggregation Load-Sharing Mode:
Layer 2 traffic: packet type-based sharing
Layer 3 traffic: packet type-based sharing
# Display the set global link-aggregation load sharing mode.
<Sysname> display link-aggregation load-sharing mode
Link-Aggregation Load-Sharing Algorithm:
Algorithm 2
Link-Aggregation Load-Sharing Seed:
0x3ff
Link-Aggregation Load-Sharing Mode:
destination-mac address
# Display the default link-aggregation load sharing modes of Layer 2 aggregation group 10.
<Sysname> display link-aggregation load-sharing mode interface bridge-aggregation 10
Bridge-Aggregation10 Load-Sharing Mode:
Layer 2 traffic: packet type-based sharing
Layer 3 traffic: packet type-based sharing
# Display the configured link-aggregation load sharing mode of Layer 2 aggregation group 10.
load-sharing
mode
source-mac address
84
[
interface
[
bridge-aggregation
Advertisement
Table of Contents
