Nordson VersaBlue VBN 50 Manual page 20

1-10
Safety
General Safety Warnings and Cautions
Equipment
Type
HM, PC
HM, CA, PC
HM, CA, PC
HM, CA, PC
A1EN−01−[XX−SAFE]−10
Table 1-1 General Safety Warnings and Cautions (contd)
WARNING: Equipment starts automatically! Remote triggering
devices are used to control automatic hot melt guns. Before working
on or near an operating gun, disable the gun's triggering device and
remove the air supply to the gun's solenoid valve(s). Failure to
disable the gun's triggering device and remove the supply of air to the
solenoid valve(s) can result in personal injury.
WARNING: Risk of electrocution! Even when switched off and
electrically isolated at the disconnect switch or circuit breaker, the
equipment may still be connected to energized auxiliary devices.
De-energize and electrically isolate all auxiliary devices before
servicing the equipment. Failure to properly isolate electrical power to
auxiliary equipment before servicing the equipment can result in
personal injury, including death.
WARNING: Risk of fire or explosion! Nordson adhesive equipment is
not rated for use in explosive environments and should not be used
with solvent-based adhesives that can create an explosive
atmosphere when processed. Refer to the MSDS for the adhesive to
determine its processing characteristics and limitations. The use of
incompatible solvent-based adhesives or the improper processing of
solvent-based adhesives can result in personal injury, including death.
WARNING: Allow only personnel with appropriate training and
experience to operate or service the equipment. The use of untrained
or inexperienced personnel to operate or service the equipment can
result in injury, including death, to themselves and others and can
damage the equipment.
(contd)
Warning or Caution
Continued...
E 2004 Nordson Corporation